BHX 055

Ein paar mehr Informationen wären schon hilfreich.

T&BTischlerei

Wenn die Maschine-Spindel mehr wie 6Monate nicht benützt wurde muss wohl das Fett in der Spndel von einem Technicker neu verteilt werden und das wird wohl auch überwacht wies aussieht.

Dann würd ich mal beim Service anrufen.

Das muss jetzt nicht wirklich wegen dem Fett sein, kam mir nur passend vor vermutlich auch wegen den wenigen infos.

Wenn man mal ein Problem hat kurz schildern was das Problem ist ob irgend etwas passiert ist was das Problem herbeigeführt hat sonst kann man nur raten.

Hello!

You should run a program called "spindle" that resets the long pause state of the spindle. You may find the program in the service folder. This error usually occurs if the machine has not been used for a long time or the motherboard battery has run out/been replaced. In this case, commissioning can only be done by running the "spindle" program. The program must be run from the beginning to the end to remove the error.

-Sami

Quote from samiki

Hello!

You should run a program called "spindle" that resets the long pause state of the spindle. You may find the program in the service folder. This error usually occurs if the machine has not been used for a long time or the motherboard battery has run out/been replaced. In this case, commissioning can only be done by running the "spindle" program. The program must be run from the beginning to the end to remove the error.

-Sami

Is this similar to the "prepare machine" which is run every time at start up?

Quote from cbl123

Is this similar to the "prepare machine" which is run every time at start up?

Hello!

This is not the same function. When starting the machine, the so-called reference run/warm-up run is different than this "spindle" program. The spindle program is only needed in certain situations. This spindle activation, "spindle" program is also mentioned in the machine manuals. The running of the program is also constantly monitored, so it must always be completed from start to finish.

-Sami

Quote from samiki

Hello!

This is not the same function. When starting the machine, the so-called reference run/warm-up run is different than this "spindle" program. The spindle program is only needed in certain situations. This spindle activation, "spindle" program is also mentioned in the machine manuals. The running of the program is also constantly monitored, so it must always be completed from start to finish.

-Sami

Thanks for the explanation.

another query I had, was if anyone else runs a warm up program for the XY&Z drives?

I know this is common on milling machines, and I have experienced a change in accuracy once the machine has been in use for the day.