Keep spindle down

  • I'm using Cut Rite V10, and I'd like to keep the spindle down just above the board for all router cuts until routing is finished. Cutting a 19mm board I'd like to rapid down to 22mm, route the first part, move Z back to 22mm, rapid to next part. Currently the spindle makes a route, returns to Z home on every route.

  • Hi SoutherIndiana,


    the later releases of Cut Rite V10 had some more nesting options, like "stay down" (probably what you are looking for) or tabs. I have attached a screenshot from a V10.04 where you can find the settings in the "Part Division" tab of the nesting parameters


Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!