Hello Woodwop team.
I have Woodwop 5.0 - (Build 852.0) at machine Weeke Venture 1M
I have these MPR than include an NC stop. Optimization for vertical drilling is off.
The program starts as expected.
In both files, after the NC stop it drills only the first hole and then it stops like the program is normally finished
The other 4 are not executed. It is like they do not exist. No error message.
If I hide commands before NC stop and leave only these 4 holes, then they are drilled as expected.
(I tried to alter their coordinates 0.1mm because they are identical with the first holes of the program, just in case it gets confused and assumes they are drilled. The problem still exists)
This is huge problem because we have to be careful all the time when there is NC stop. It happens only with NC stop and not always. Something triggers this problem at specific files.