Component inverted when changing local coordinates

  • Hello!

    I have a spiral drill component. The tool works in the center when I use this component on local coordinate system 0.

    if I put it on local coordinate system 3, the tool changes sides and works outside.

    Does anyone know how to reverse the machining side when I change the coordinate system?

    Thanks

  • Hello!

    You have to do two operations and control it with a variable on a case-by-case basis. The mirroring condition does not recognize the local coordinate change.

    In general, it is recommended to always place the component according to the 0 corner and calculate the location from the other corners, e.g. based on _BSX and _BSY data or from the variables determining the size of the piece.

    -Sami

Jetzt mitmachen!

Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!