programmed tool id? does not match drills in drill head

  • Brand new to the forum here, we use Cabinet Vision and are trying to send our first full sheet of parts to the router. Can anyone tell me where we might start fix this error?

    Would it be:

    A bad post

    tool setup in CV

    or maybe a tool setup on the Router?

  • Your machine (drill head) doesn't have a drill coming through from cabinet vision. It could be that Cabinet Vision uses through bits and you don't have one on your machine. Could be also a certain diameter you need. Check the drills Cabinet Vision is exporting and if you got them in the drill head.

  • Thanks for your input! the problem was that we had a bit set up as a through bit on the Homag that needed to be set to Through\Blind.

Jetzt mitmachen!

Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!