Posts by JOYBOY

    Hallo,

    du kannst das mpr mit einem Editor öffnen, dann kannst du nach ZA="20" suchen und mit deinem neuen Wert z.b. ZA="15" ersetzen. So kannst du schnell alle Parameterfelder in Z änden. Ich hoffe, dass das so gewollt war1

    thank you

    Merhaba!

    İşte dxf dosyası örneği. Bu autocad ile yapılmamalıdır. Hatların zincirlenmesinde sorunlar olabilir. woodWOP yaparak yine boyutlara göre değişmesini sağlıyorsunuz ama bir dxf dosyası ile her boyutu ayrı ayrı yapmanız gerekiyor. Ek olarak, frezelemenin çizgiyi takip ettiği ayarları elde etmek için dxf-import professional programına ihtiyacınız olabilir.

    -Sami

    I understood everything from the dxf you sent. hmm, the corners should be combined and it should go down from the bottom up and again from the top in the corners and end in the middle of the drawing, not in the corners. very sensible thank you very much

    I want to make a rustic model now the weeke woodwop system is a little different, dxf also shows the model at the base. I watched woodwop 5 videos and did not understand much. because it was using inch and different shortcut coordinates. How can I do it according to the knife size I sent in dxf in order to make the corners properly. can you help with this. can you show me a sample drawing. thankyou

    Hello, I reinstalled the woodwop program I used. but the program gives "no disk" error. I need the woodvop v.4.0 program. Or how can I edit the program I have. Hallo, ich habe das von mir verwendete Woodwop-Programm neu installiert. Das Programm gibt jedoch den Fehler "Keine Festplatte" aus. Ich brauche das Programm woodvop v.4.0. Oder wie kann ich mein Programm bearbeiten?


    Model : weeke optimat bp145

    Program : Woodwop 4.0

    Hello, I reinstalled the woodwop program I used. but the program gives "no disk" error. I need the woodvop v.4.0 program. Or how can I edit the program I have. Hallo, ich habe das von mir verwendete Woodwop-Programm neu installiert. Das Programm gibt jedoch den Fehler "Keine Festplatte" aus. Ich brauche das Programm woodvop v.4.0. Oder wie kann ich mein Programm bearbeiten?

    Model : weeke optimat bp145
    Program : Woodwop 4.0