Announcement

Collapse
No announcement yet.

NC Stop-Reposisioning

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • NC Stop-Reposisioning

    Hi, Id be grateful if someone can tell me why I can't make the attached mpr run as I expect?

    The panels pockets are symmetrical in the y but after the NC stop and I turn the panel over I am struggling to line the subsequent pockets symmetrically again.
    I have lined the pockets in the X using the "New Offset dimension" setting, however it dos not seem to work for the Y axis for some reason.

    Best regard,
    Phil.
    Attached Files

  • #2
    Hello!

    I made small changes to the NC-stop values. Try this program. I have noticed that the same, nc-stop command works differently than Homag machines and Weeke machines. NC-stop repositioning works in place and is dependent on the mirroring value of the place.

    -Sami
    Attached Files

    Comment


    • #3
      Thank you for your help I believe I finally understand it.

      Comment

      Working...
      X