Announcement

Collapse
No announcement yet.

Changing Depth during Cut

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Changing Depth during Cut

    Is it possible to cut at different depths along the same path. For example, can I start the rout at 1/8" deep and have it finish at 1/2" deep. I know I can step cut
    but I want to make a continuous rout. Using woodwop 5 and autocad LT 2010

  • #2
    Hello!

    That is possible. You can make line and change that line z-position on start or end point. Then vertical trimming deep set @0. By doing this, the machining follows the line. Another possibility is to make nc-change to Z-value.

    -Sami
    Attached Files

    Comment


    • #3
      Thank you Samiki
      I will give this a try.

      Comment

      Working...
      X