No announcement yet.

NC-stop Homag machines

  • Filter
  • Time
  • Show
Clear All
new posts

  • NC-stop Homag machines


    There would be a few questions for Homag on the NC-stop command.

    I've been working on weeke machines and now HOMAG machines. I noticed that the NC-stop is not the same. When the program works on homag machines in place 1 without mirroring the NC-stop works the same way as on weeke machines. But if the workpiece is machined, for example, at position 4 with X-mirroring on, then the NC-stop zero value should be set to the same as the raw part over dimension X. By doing this, turning the part is a possible move back to zero to succeed. Have others noticed the same or is the machine code wrong? The function seems strange and is against the instructions.