Announcement

Collapse
No announcement yet.

Woodwop 5 - some questions

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Woodwop 5 - some questions

    Is it possible to move the XYZ zero point from top right to top let of the workpiece.

    Also, is there any way to display a message to the operator when the program cycle is in Stop mode ?

    Thanks

    Gary Smith, Woods Furniture

  • #2
    Hello!

    if you mean the nc-stop command then you have the option to show the message to the operator. In the nc-stop command, check the box "Output message at the appropriate time" and enter the desired message in the field below. See the picture below.

    As far as I know, moving a zero point is not possible. But of course you can start drawing the geometry by changing the start corner from the original 0 -> 3. Of course this does not turn the part, but the dimensioning is now done from that corner. When using this, you must take into account the mirroring of machining.

    -Sami
    Attached Files

    Comment


    • #3
      Hi Sami, thanks for your help

      Comment

      Working...
      X