Announcement

Collapse
No announcement yet.

BHX200 thickness measurement dependency

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • BHX200 thickness measurement dependency

    Is anyone on here familiar with the BHX200's or BHX055? they are very similar and I am having an issue with some horizontal drilling on my BHX200. I would like to set up a measurement dependency for the Z. I am not sure that these machines are equipped with the appropriate tool to measure the Z. I have tried to get it to work in woodWOP with no success.

    Any help would be wonderful.

    Thanks

  • #2
    Hello!
    The BHX 055 can´t do that but the BHX 200
    In the enclosed program the thickness is programmed with 14,5 mm.
    When you put the workpiece into the machine the thickness.will be measured.
    If you want to drill into the measured center then you have to write Z Value with _BSZ / 2
    Then you do not drill at Z7,25 but at the actually measured middle
    I hope that is what you are looking for.

    Attached Files

    Comment

    Working...
    X